[93 98-03, 900 94-98]
| STEP 1 | Lift up car with stands or lift and cover fenders to prevent scraping paint |
| STEP 2 | Remove Front Grille, intake cover, battery cover, battery leads and battery |
| STEP 3 | Remove the mount bracket for the positive battery cable and remove the battery tray |
| STEP 4 | Put car in 4th gear and remove the gearbox plug (plastic) and lock in gear by inserting pin |
| STEP 5 | Remove securing clip that holds selector rod to linkage |
| STEP 6 | Inside car lift up shifter rubber, engage 3rd gear pulling shift rod away from outside linkage and fit pin in hold visible after removing the rubber shifter cover. This locks car inside to 3rd gear |
| STEP 7 | Push in clutch about 2 inches to prevent fluid from coming out of reservoir |
| STEP 8 | Remove slave clip that holds line to slave and reinstall clip after line has been removed |
| STEP 9 | Remove reverse light connector at rear of transmission |
| STEP 10 | Disconnect positive battery cable bracket to engine |
| STEP 11 | Remove top 3 gearbox bolts and fit locating studs if you have them. This will help during reassembly |
| STEP 12 | Remove alternator connections |
| STEP 13 | Remove oxygen sensor connections |
| STEP 14 | Remove the gear selector linkage in the engine compartment |
| STEP 15 | Remove the rear engine mount nut and loosen the bolts that hold in that mount |
| STEP 16 | Lift engine slightly and remove the bolts that hold the mount to the sub frame |
| STEP 17 | Lift car and remove front wheels and remove the right hand inner liner that covers the serpentine belt |
| STEP 18 | Remove the header pipe completely from the car. You must do this or you can damage the flex joint |
| STEP 19 | Remove the rear engine mount and torque arm. |
| STEP 20 | Remove the Shift linkage as well |
| STEP 21 | Remove the steering gear screws and the screws that hold the line to the sub frame as well |
| STEP 22 | Remove the Air filter housing as well |
| STEP 23 | Remove AC lines from line clips on sub frame |
| STEP 24 | Remove the engine oil cooler and intercooler |
| STEP 25 | Remove the radiator |
| STEP 26 | Remove the outer ball joint bolts |
| STEP 27 | Remove the sub frame with Saab lift or the like by removing the remaining 6 bolts that hold the sub frame in. Don't forget any washers that fall |
| STEP 28 | Drain Gearbox oil & remove the Left drive shaft with a spanner-type tool |
| STEP 29 | Lower the car and remove the bolt from the left engine mount |
| STEP 30 | Remove the battery ground from transmission and the transmission mount |
| STEP 31 | Remove the transmission by lowering the engine to clear the body of car and dropping the transmission out. These transmissions are not tremendously heavy but they are awkward and hard to handle. Use trans dropping jack to remove by removing the final two transmission bolts |
Pricing for 93 98-03 Transmissions (Transmission Parts (Auto))
Pricing for 93 98-03 Transmissions (Transmission Parts (Manual)) |
