Cabin Fan Control Unit Replacement

[Saab 95]

Removal

STEP 1

Remove the windshield wiper arms with saab puller tool 8580144

STEP 2

Remove the rubber seals on the wiper spindles

STEP 3

Remove the rubber molding along the front bulkhead and loosen the clips on one side. Place the molding to the one side

STEP 4

Loosen the cover over the bulkhead partition space (fastened with clips) by carefully lifting it foward, releasing it from the windshield

STEP 5

Move the hood cables and lift the cover backwards towards the windshield

STEP 6

Be careful when removing clips!

STEP 7

Loosen the clips on the front edge of the water shield with a screwdriver and remove the water shield

STEP 8

Free the wiring harness over the cabin fan held with clips

STEP 9

Press down the wiring harness including the rubber seal to the control unit

STEP 10

Remove the glove box (See glove box removal section) /95/saab-glove-box-removal.htm

STEP 11

Unplug and remove the connector from the bracket

STEP 12

Unscrew the control unit from the fresh-air filter cover

STEP 13

Reverse process to install