IGNITION SWITCH MODULE REPLACEMENT

Removal

STEP 1

Ground yourself my touching the car body before starting and avoid touching the electrical pins when removing equipment

STEP 2

Move the driver and passenger seats to their rearmost position

STEP 3

Remove the front side pieces from the center console

STEP 4

Remove the cover over the gear lever housing using saab removal tool 8293474 in the rear edge and pull back

STEP 5

Remove the clamp (Auto Trans)

STEP 6

Remove the cover under the handbrake by pulling it straight out

STEP 7

Remove the cover on the passenger side by squeezing the cover and lifting it up. Remove the compartment under the cover

STEP 8

Lift up the rubber mat in the center console storage compartment and remove the screws

STEP 9

Remove the center console screws, note the screws for the plastic and aluminium are different

STEP 10

Remove the sound insulation if equiped

STEP 11

Press in the four catches on the sides and press down the ignition switch module

STEP 12

Remove the ignition switch module by slightly lifting the center console

STEP 13

Remove the connector

STEP 14

Reverse process for installation. You may have to connect to a tech2 tool to clear any DTC codes